Lite-On iHES208 User Manual download pdf (Page 10)

ENGLISH

ARDWARE

NSTALLATION OF

ERIAL

ATA

RIVES

1. Turn off your PC and disconnect all power cords.

2. Refer to your PC user's manual to remove the PC cover.

3. Find an empty bay, slide the drive into the bay and mount the drive by using 4 screws.

4. Connect a Serial ATA data cable to the Primary or Secondary Serial ATA port on the

motherboard or PCI card of your PC.

5. Connect the other end of the Serial ATA data cable to your drive.

NOTE: The pin definition of Serial ATA data cable connector should be the same as that

in the following figure.

6. (Optional) It may be necessary for you to use a 4-pin IDE to Serial ATA power adapter.

It depends on the power connectors of your PC power supply. If one is required, attach

this 4-pin to Serial ATA power adapter to the 4-pin power connector from your PC

power supply.

7. Connect the Serial ATA power connector to the power connector on the rear panel of

your drive.

NOTE: The Serial ATA power connector is larger than the Serial ATA data cable

connector. And the pin definition of Serial ATA power connector should be the

same as that in the following figure.

8. Put the PC cover back and connect the power cords.

Figure: Rear Panel of Serial ATA Drive

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

No comments

Lite-On iHES208 User Manual Page 10