Lite-On DH-204AP09C Datasheet

1 ENGLISHSAFETY INSTRUCTIONS Please read all instructions carefully and keep this User’s Manual for your reference. Carefully note all Cautions and W

10 ENGLISHHARDWARE INSTALLATION OF ATAPI/E-IDE DRIVES Installing the DVD Writer This chapter explains how to physically install your DVD writer in yo

11 ENGLISH Changing the Jumper The Master/Slave jumper can be used to set the DVD writer to Master (MA) or Slave (SL) setting, as shown below. Do not

12 ENGLISH Configuration (B) Current configuration: Hard disk connected as Master device and CD-ROM or DVD-ROM connected as Slave on the primary IDE

13 ENGLISH Configuration (C) Current configuration: Two hard disk drives connected as Master and Slave devices on the primary IDE port; CD-ROM or DV

14 ENGLISHINSTALLATION, CONTINUED 4. Connect the necessary cables to your DVD Writer. Figure: Connecting Cables (A) IDE Cable: Plug one connecto

15 ENGLISH 5. Carefully slide the DVD writer horizontally into the empty bay and secure it to the PC chassis, then replace the computer cover. 6.

16 ENGLISHHARDWARE INSTALLATION OF SERIAL ATA DRIVES 1. Turn off your PC and disconnect all power cords. 2. Refer to your PC user's manual to

17 ENGLISHOPERATION Installing Device Drivers and Software Your Windows system already has device drivers that let you use the DVD writer to install

18 ENGLISH Loading and Unloading the Tray (1) While the DVD writer is powered up, push the Eject button on the front panel to eject the tray. (2)

19 ENGLISHRECORDING & PLAYING Recording CDs & DVDs To record CDs and DVDs, ensure that you have installed the proper software (see previous p

2 ENGLISHFCC COMPLIANCE STATEMENT Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

20 ENGLISHRECOMMENDED RECORDABLE & REWRITABLE MEDIA For consistent high quality, we recommend CD and DVD media from the following manufacturers (

21 ENGLISHLIGHTSCRIBE USER GUIDE The following LightScribe chapters are instruction for which support LightScribe disc labeling drive. Please refer

22 ENGLISHCREATING AND BURNING LIGHTSCRIBE-LABELED DISCS 1. Start the LightScribe labeling software. Your labeling application may be part of your d

23 ENGLISHFREQUENTLY ASKED QUESTIONS Q: How does LightScribe work? A: The coating on a LightScribe disc changes color when it’s exposed to the CD/D

24 ENGLISHTROUBLESHOOTING If you have trouble during installation or use of your DVD writer, please refer to the following information. Read Problems

25 ENGLISH Write Problems Symptom Possible Cause Solution Authoring software used does not support your DVD writer  Use the authoring software prov

3 ENGLISHRECAUTIONS CAUTION: Do not attempt to open the drive for service. Removing the cover may cause exposure to harmful laser beams and electric

4 ENGLISHTABLE OF CONTENTS INTRODUCTION What You Can Do with the DVD Writer……………………………5 Format Compatibility…………………………………………………6 Recording Modes Supp

5 ENGLISHINTRODUCTION This DVD writer provides professional-quality DVD and CD performance for writing, rewriting and reading. It supports Running OP

6 ENGLISH Format Compatibility DVD write: DVD+R Version 1.3, DVD+R9 Version 1.0 (only for drives that support double-layer DVD+R writing), DVD-R9 Ver

7 ENGLISHSYSTEM CONFIGURATION System Requirements To ensure stable read/write/rewrite performance, a Windows-based PC system with the following featu

8 ENGLISHFEATURES AND CONTROLS Front View Figure: Representative front view of DVD writer (your drive may differ) A Eject / Close Button Push butt

9 ENGLISH Rear View For ATAPI/E-IDE Drives: Figure: Rear view of ATAPI/E-IDE drive Power Connector Four-pin connector for DC power input. Host IDE I